If you’re new to installing banners with bungee cords, then you’re probably at least familiar with how annoying and difficult to use bungee cords can be at times. Let’s face it—if you’ve ever played with bungee cords, even for five seconds, chances are that the first few (or more…) times, you accidentally snapped it the wrong way and accidentally smacked yourself. Although humorous, this is often a pain. If you’re trying to put up vinyl banners, you want to get it done and over with. That’s time that could be used advertising that you’re wasting. So what are a few tips for installing banners with bungee cords?
About the Bungee Cord
First of all, don’t hyperextend your cords when you’re installing banners with bungee cords. This is what leads to someone accidentally smacking themselves in the eye with the bungee cord. However, you do want to try to stretch the cords just a tiny bit, if not to loosen them, then to at least get you prepared to stretch them far enough to attach them. Make sure that you also have bungee cords that are long enough to stretch from where you need them to be attached to your banners and that they fit through the grommets. This is one of the most important things that you should do when installing banners with bungee cords.
Then you have the banner. Your banner should have grommets installed—otherwise, installing banners with bungee cords won’t help you. If you try to rip a hole for the bungee cords to fit through, all that’s going to do is cause your banners to deteriorate and rip. In short, stick to grommets.
Finally, installing banners with bungee cords
To install, you will need to carefully slip the end of the bungee’s hook into the grommet. Make sure that it fits well. Next, attach the other end to the pole, car, etc, that you are trying to install it on. Then, leave it there. After that, you’re good to go! These are just a few quick and simple tips for installing banners with bungee cords.