How to Set-Up Jumbo Backdrop Stands

JUMBO BACKDROP STAND SET-UP AND BANNER INSTALLATION GUIDE

Contents: Two [2] metal feet, two [2] large telescoping poles, two [2] small telescoping poles with fixed bolt at end, and two [2] small telescoping poles without fixed bolts.

1 - Attach the flat ends of one large pole to one of the metal feet using a screw.  Repeat with the other large pole and metal foot.

2 - Connect one of the small poles with a fixed bolt to one of the small poles without a fixed bolt by screwing them together.  Repeat this with the remaining poles. You should now have two long poles with a nut at each of their ends.

3 - Lay the banner out flat and adjust the poles to be wider then the width of the banner.

4 - Insert one long pole through the banner's bottom pole pocket, then attach this pole horizontally to both of the vertical poles with the nuts on either side near the base.

5 - Repeat the actions from Step 5 for top pole pocket of the banner and attach this using the top holes on the vertical poles.

6 - YOUR JUMBO BACKDROP BANNER STAND IS READY TO USE!

LIGHT DUTY JUMBO BACKDROP STAND SET-UP AND BANNER INSTALLATION GUIDE

Contents: One [1] Philips head screwdriver and two [2] screws, two [2] metal feet, two [2] telescoping poles with rounded ends, two [2] telescoping poles with flat ends, and four [4] bolts with knobs.

1 - Insert one of the flat-ended poles into the circular hole in a metal foot and use a Philips head screw to secure the pole to the metal foot with the screwdriver. Repeat this for the second flat-ended pole and metal foot.

2 - Adjust height of each pole attached to the feet as needed.

3 - Lay banner out flat, take one of the round-ended poles and adjust its length so that it is longer than the banner's width and extends out from both sides of the banner's pole pocket.

4 - Insert adjusted pole through the banner's bottom pole pocket. Attach this pole to the two vertical poles previously attached to the metal feet with two bolts near the base.

5 - Repeat size adjustment Steps 4 and 5 with the top horizontal bar before inserting it through the banner's top pole pocket. Attach this pole using the top holes on the vertical poles with the two remaining bolts.

6 - YOUR LIGHT DUTY JUMBO BACKDROP BANNER STAND IS READY TO USE!!