How to Set-Up Jumbo Backdrop Stands
JUMBO BACKDROP STAND SET-UP AND BANNER INSTALLATION GUIDE
Contents: Two  metal feet, two  large telescoping poles, two  small telescoping poles with fixed bolt at end, and two  small telescoping poles without fixed bolts.
1 - Attach the flat ends of one large pole to one of the metal feet using a screw. Repeat with the other large pole and metal foot.
2 - Connect one of the small poles with a fixed bolt to one of the small poles without a fixed bolt by screwing them together. Repeat this with the remaining poles. You should now have two long poles with a nut at each of their ends.
3 - Lay the banner out flat and adjust the poles to be wider then the width of the banner.
4 - Insert one long pole through the banner's bottom pole pocket, then attach this pole horizontally to both of the vertical poles with the nuts on either side near the base.
5 - Repeat the actions from Step 5 for top pole pocket of the banner and attach this using the top holes on the vertical poles.
6 - YOUR JUMBO BACKDROP BANNER STAND IS READY TO USE!
LIGHT DUTY JUMBO BACKDROP STAND SET-UP AND BANNER INSTALLATION GUIDE
Contents: One  Philips head screwdriver and two  screws, two  metal feet, two  telescoping poles with rounded ends, two  telescoping poles with flat ends, and four  bolts with knobs.
1 - Insert one of the flat-ended poles into the circular hole in a metal foot and use a Philips head screw to secure the pole to the metal foot with the screwdriver. Repeat this for the second flat-ended pole and metal foot.
2 - Adjust height of each pole attached to the feet as needed.
3 - Lay banner out flat, take one of the round-ended poles and adjust its length so that it is longer than the banner's width and extends out from both sides of the banner's pole pocket.
4 - Insert adjusted pole through the banner's bottom pole pocket. Attach this pole to the two vertical poles previously attached to the metal feet with two bolts near the base.
5 - Repeat size adjustment Steps 4 and 5 with the top horizontal bar before inserting it through the banner's top pole pocket. Attach this pole using the top holes on the vertical poles with the two remaining bolts.
6 - YOUR LIGHT DUTY JUMBO BACKDROP BANNER STAND IS READY TO USE!!
Don't see what you're looking for?
Other Banner Stand Products